The RFC Archive
 The RFC Archive   RFC 2012   « Jump to any RFC number directly 
 RFC Home
Full RFC Index
Recent RFCs
RFC Standards
Best Current Practice
RFC Errata
1 April RFC



IETF RFC 2012

SNMPv2 Management Information Base for the Transmission Control Protocol using SMIv2

Last modified on Tuesday, December 3rd, 1996

Permanent link to RFC 2012
Search GitHub Wiki for RFC 2012
Show other RFCs mentioning RFC 2012







Network Working Group                              K. McCloghrie, Editor
Request for Comments: 2012                                 Cisco Systems
Updates: 1213                                              November 1996
Category: Standards Track 


                   SNMPv2 Management Information Base
           for the Transmission Control Protocol using SMIv2

 Status of this Memo

   This document specifies an Internet standards track protocol for the
   Internet community, and requests discussion and suggestions for
   improvements.  Please refer to the current edition of the "Internet
   Official Protocol Standards" (STD 1) for the standardization state
   and status of this protocol.  Distribution of this memo is unlimited.

 IESG Note:

   The IP, UDP, and TCP MIB modules currently support only IPv4.  These
   three modules use the IpAddress type defined as an OCTET STRING of
   length 4 to represent the IPv4 32-bit internet addresses.  (See RFC
   1902, SMI for SNMPv2.)  They do not support the new 128-bit IPv6
   internet addresses.

 Table of Contents

   1. Introduction ................................................    1
   2. Definitions .................................................    2
   2.1 The TCP Group ..............................................    3
   2.2 Conformance Information ....................................    8
   2.2.1 Compliance Statements ....................................    8
   2.2.2 Units of Conformance .....................................    9
   3. Acknowledgements ............................................   10
   4. References ..................................................   10
   5. Security Considerations .....................................   10
   6. Editor's Address ............................................   10

1.  Introduction

   A management system contains: several (potentially many) nodes, each
   with a processing entity, termed an agent, which has access to
   management instrumentation; at least one management station; and, a
   management protocol, used to convey management information between
   the agents and management stations.  Operations of the protocol are
   carried out under an administrative framework which defines
   authentication, authorization, access control, and privacy policies.




McCloghrie                  Standards Track                  PAGE 1 top


RFC 2012 SNMPv2 MIB for TCP November 1996 Management stations execute management applications which monitor and control managed elements. Managed elements are devices such as hosts, routers, terminal servers, etc., which are monitored and controlled via access to their management information. Management information is viewed as a collection of managed objects, residing in a virtual information store, termed the Management Information Base (MIB). Collections of related objects are defined in MIB modules. These modules are written using a subset of OSI's Abstract Syntax Notation One (ASN.1) [1], termed the Structure of Management Information (SMI) [2]. This document is the MIB module which defines managed objects for managing implementations of the Transmission Control Protocol (TCP) [3]. The managed objects in this MIB module were originally defined using the SNMPv1 framework as a part of MIB-II [4]. This document defines the same objects for TCP using the SNMPv2 framework. 2. Definitions TCP-MIB DEFINITIONS ::= BEGIN IMPORTS MODULE-IDENTITY, OBJECT-TYPE, Integer32, Gauge32, Counter32, IpAddress, mib-2 FROM SNMPv2-SMI MODULE-COMPLIANCE, OBJECT-GROUP FROM SNMPv2-CONF; tcpMIB MODULE-IDENTITY LAST-UPDATED "9411010000Z" ORGANIZATION "IETF SNMPv2 Working Group" CONTACT-INFO " Keith McCloghrie Postal: Cisco Systems, Inc. 170 West Tasman Drive San Jose, CA 95134-1706 US Phone: +1 408 526 5260 Email: kzm@cisco.com" McCloghrie Standards Track PAGE 2 top

RFC 2012 SNMPv2 MIB for TCP November 1996 DESCRIPTION "The MIB module for managing TCP implementations." REVISION "9103310000Z" DESCRIPTION "The initial revision of this MIB module was part of MIB- II." ::= { mib-2 49 } -- the TCP group tcp OBJECT IDENTIFIER ::= { mib-2 6 } tcpRtoAlgorithm OBJECT-TYPE SYNTAX INTEGER { other(1), -- none of the following constant(2), -- a constant rto rsre(3), -- MIL-STD-1778, Appendix B vanj(4) -- Van Jacobson's algorithm [5] } MAX-ACCESS read-only STATUS current DESCRIPTION "The algorithm used to determine the timeout value used for retransmitting unacknowledged octets." ::= { tcp 1 } tcpRtoMin OBJECT-TYPE SYNTAX Integer32 UNITS "milliseconds" MAX-ACCESS read-only STATUS current DESCRIPTION "The minimum value permitted by a TCP implementation for the retransmission timeout, measured in milliseconds. More refined semantics for objects of this type depend upon the algorithm used to determine the retransmission timeout. In particular, when the timeout algorithm is rsre(3), an object of this type has the semantics of the LBOUND quantity described in RFC 793." ::= { tcp 2 } tcpRtoMax OBJECT-TYPE SYNTAX Integer32 UNITS "milliseconds" MAX-ACCESS read-only STATUS current DESCRIPTION "The maximum value permitted by a TCP implementation for the McCloghrie Standards Track PAGE 3 top

RFC 2012 SNMPv2 MIB for TCP November 1996 retransmission timeout, measured in milliseconds. More refined semantics for objects of this type depend upon the algorithm used to determine the retransmission timeout. In particular, when the timeout algorithm is rsre(3), an object of this type has the semantics of the UBOUND quantity described in RFC 793." ::= { tcp 3 } tcpMaxConn OBJECT-TYPE SYNTAX Integer32 MAX-ACCESS read-only STATUS current DESCRIPTION "The limit on the total number of TCP connections the entity can support. In entities where the maximum number of connections is dynamic, this object should contain the value -1." ::= { tcp 4 } tcpActiveOpens OBJECT-TYPE SYNTAX Counter32 MAX-ACCESS read-only STATUS current DESCRIPTION "The number of times TCP connections have made a direct transition to the SYN-SENT state from the CLOSED state." ::= { tcp 5 } tcpPassiveOpens OBJECT-TYPE SYNTAX Counter32 MAX-ACCESS read-only STATUS current DESCRIPTION "The number of times TCP connections have made a direct transition to the SYN-RCVD state from the LISTEN state." ::= { tcp 6 } tcpAttemptFails OBJECT-TYPE SYNTAX Counter32 MAX-ACCESS read-only STATUS current DESCRIPTION "The number of times TCP connections have made a direct transition to the CLOSED state from either the SYN-SENT state or the SYN-RCVD state, plus the number of times TCP connections have made a direct transition to the LISTEN state from the SYN-RCVD state." ::= { tcp 7 } McCloghrie Standards Track PAGE 4 top

RFC 2012 SNMPv2 MIB for TCP November 1996 tcpEstabResets OBJECT-TYPE SYNTAX Counter32 MAX-ACCESS read-only STATUS current DESCRIPTION "The number of times TCP connections have made a direct transition to the CLOSED state from either the ESTABLISHED state or the CLOSE-WAIT state." ::= { tcp 8 } tcpCurrEstab OBJECT-TYPE SYNTAX Gauge32 MAX-ACCESS read-only STATUS current DESCRIPTION "The number of TCP connections for which the current state is either ESTABLISHED or CLOSE- WAIT." ::= { tcp 9 } tcpInSegs OBJECT-TYPE SYNTAX Counter32 MAX-ACCESS read-only STATUS current DESCRIPTION "The total number of segments received, including those received in error. This count includes segments received on currently established connections." ::= { tcp 10 } tcpOutSegs OBJECT-TYPE SYNTAX Counter32 MAX-ACCESS read-only STATUS current DESCRIPTION "The total number of segments sent, including those on current connections but excluding those containing only retransmitted octets." ::= { tcp 11 } tcpRetransSegs OBJECT-TYPE SYNTAX Counter32 MAX-ACCESS read-only STATUS current DESCRIPTION "The total number of segments retransmitted - that is, the number of TCP segments transmitted containing one or more previously transmitted octets." McCloghrie Standards Track PAGE 5 top

RFC 2012 SNMPv2 MIB for TCP November 1996 ::= { tcp 12 } -- the TCP Connection table -- The TCP connection table contains information about this -- entity's existing TCP connections. tcpConnTable OBJECT-TYPE SYNTAX SEQUENCE OF TcpConnEntry MAX-ACCESS not-accessible STATUS current DESCRIPTION "A table containing TCP connection-specific information." ::= { tcp 13 } tcpConnEntry OBJECT-TYPE SYNTAX TcpConnEntry MAX-ACCESS not-accessible STATUS current DESCRIPTION "A conceptual row of the tcpConnTable containing information about a particular current TCP connection. Each row of this table is transient, in that it ceases to exist when (or soon after) the connection makes the transition to the CLOSED state." INDEX { tcpConnLocalAddress, tcpConnLocalPort, tcpConnRemAddress, tcpConnRemPort } ::= { tcpConnTable 1 } TcpConnEntry ::= SEQUENCE { tcpConnState INTEGER, tcpConnLocalAddress IpAddress, tcpConnLocalPort INTEGER, tcpConnRemAddress IpAddress, tcpConnRemPort INTEGER } tcpConnState OBJECT-TYPE SYNTAX INTEGER { closed(1), listen(2), synSent(3), synReceived(4), established(5), finWait1(6), McCloghrie Standards Track PAGE 6 top

RFC 2012 SNMPv2 MIB for TCP November 1996 finWait2(7), closeWait(8), lastAck(9), closing(10), timeWait(11), deleteTCB(12) } MAX-ACCESS read-write STATUS current DESCRIPTION "The state of this TCP connection. The only value which may be set by a management station is deleteTCB(12). Accordingly, it is appropriate for an agent to return a `badValue' response if a management station attempts to set this object to any other value. If a management station sets this object to the value deleteTCB(12), then this has the effect of deleting the TCB (as defined in RFC 793) of the corresponding connection on the managed node, resulting in immediate termination of the connection. As an implementation-specific option, a RST segment may be sent from the managed node to the other TCP endpoint (note however that RST segments are not sent reliably)." ::= { tcpConnEntry 1 } tcpConnLocalAddress OBJECT-TYPE SYNTAX IpAddress MAX-ACCESS read-only STATUS current DESCRIPTION "The local IP address for this TCP connection. In the case of a connection in the listen state which is willing to accept connections for any IP interface associated with the node, the value 0.0.0.0 is used." ::= { tcpConnEntry 2 } tcpConnLocalPort OBJECT-TYPE SYNTAX INTEGER (0..65535) MAX-ACCESS read-only STATUS current DESCRIPTION "The local port number for this TCP connection." ::= { tcpConnEntry 3 } tcpConnRemAddress OBJECT-TYPE McCloghrie Standards Track PAGE 7 top

RFC 2012 SNMPv2 MIB for TCP November 1996 SYNTAX IpAddress MAX-ACCESS read-only STATUS current DESCRIPTION "The remote IP address for this TCP connection." ::= { tcpConnEntry 4 } tcpConnRemPort OBJECT-TYPE SYNTAX INTEGER (0..65535) MAX-ACCESS read-only STATUS current DESCRIPTION "The remote port number for this TCP connection." ::= { tcpConnEntry 5 } tcpInErrs OBJECT-TYPE SYNTAX Counter32 MAX-ACCESS read-only STATUS current DESCRIPTION "The total number of segments received in error (e.g., bad TCP checksums)." ::= { tcp 14 } tcpOutRsts OBJECT-TYPE SYNTAX Counter32 MAX-ACCESS read-only STATUS current DESCRIPTION "The number of TCP segments sent containing the RST flag." ::= { tcp 15 } -- conformance information tcpMIBConformance OBJECT IDENTIFIER ::= { tcpMIB 2 } tcpMIBCompliances OBJECT IDENTIFIER ::= { tcpMIBConformance 1 } tcpMIBGroups OBJECT IDENTIFIER ::= { tcpMIBConformance 2 } -- compliance statements tcpMIBCompliance MODULE-COMPLIANCE STATUS current DESCRIPTION "The compliance statement for SNMPv2 entities which implement TCP." MODULE -- this module McCloghrie Standards Track PAGE 8 top

RFC 2012 SNMPv2 MIB for TCP November 1996 MANDATORY-GROUPS { tcpGroup } ::= { tcpMIBCompliances 1 } -- units of conformance tcpGroup OBJECT-GROUP OBJECTS { tcpRtoAlgorithm, tcpRtoMin, tcpRtoMax, tcpMaxConn, tcpActiveOpens, tcpPassiveOpens, tcpAttemptFails, tcpEstabResets, tcpCurrEstab, tcpInSegs, tcpOutSegs, tcpRetransSegs, tcpConnState, tcpConnLocalAddress, tcpConnLocalPort, tcpConnRemAddress, tcpConnRemPort, tcpInErrs, tcpOutRsts } STATUS current DESCRIPTION "The tcp group of objects providing for management of TCP entities." ::= { tcpMIBGroups 1 } END McCloghrie Standards Track PAGE 9 top

RFC 2012 SNMPv2 MIB for TCP November 1996 3. Acknowledgements This document contains a modified subset of RFC 1213. 4. References [1] Information processing systems - Open Systems Interconnection - Specification of Abstract Syntax Notation One (ASN.1), International Organization for Standardization. International Standard 8824, (December, 1987). [2] McCloghrie, K., Editor, "Structure of Management Information for version 2 of the Simple Network Management Protocol (SNMPv2)", RFC 1902, Cisco Systems, January 1996. [3] Postel, J., "Transmission Control Protocol - DARPA Internet Program Protocol Specification", STD 7, RFC 793, DARPA, September 1981. [4] McCloghrie, K., and M. Rose, "Management Information Base for Network Management of TCP/IP-based internets: MIB-II", STD 17, RFC 1213, March 1991. [5] Jacobson, V., "Congestion Avoidance and Control", SIGCOMM 1988, Stanford, California. 5. Security Considerations Security issues are not discussed in this memo. 6. Editor's Address Keith McCloghrie Cisco Systems, Inc. 170 West Tasman Drive San Jose, CA 95134-1706 US Phone: +1 408 526 5260 EMail: kzm@cisco.com McCloghrie Standards Track PAGE 10 top

SNMPv2 Management Information Base for the Transmission Control Protocol using SMIv2 RFC TOTAL SIZE: 16818 bytes PUBLICATION DATE: Tuesday, December 3rd, 1996 LEGAL RIGHTS: The IETF Trust (see BCP 78)


RFC-ARCHIVE.ORG

© RFC 2012: The IETF Trust, Tuesday, December 3rd, 1996
© the RFC Archive, 2024, RFC-Archive.org
Maintainer: J. Tunnissen

Privacy Statement