The RFC Archive
 The RFC Archive   RFC 4049   « Jump to any RFC number directly 
 RFC Home
Full RFC Index
Recent RFCs
RFC Standards
Best Current Practice
RFC Errata
1 April RFC



IETF RFC 4049

BinaryTime: An Alternate Format for Representing Date and Time in ASN.1

Last modified on Thursday, April 7th, 2005

Permanent link to RFC 4049
Search GitHub Wiki for RFC 4049
Show other RFCs mentioning RFC 4049







Network Working Group                                        R. Housley
Request for Comments: 4049                               Vigil Security
Category: Experimental                                     April 2005


                              BinaryTime:
      An Alternate Format for Representing Date and Time in ASN.1

 Status of This Memo

   This memo defines an Experimental Protocol for the Internet
   community.  It does not specify an Internet standard of any kind.
   Discussion and suggestions for improvement are requested.
   Distribution of this memo is unlimited.

 Copyright Notice

   Copyright © The Internet Society (2005).

 Abstract

   This document specifies a new ASN.1 type for representing time:
   BinaryTime.  This document also specifies an alternate to the
   signing-time attribute for use with the Cryptographic Message Syntax
   (CMS) SignedData and AuthenticatedData content types; the binary-
   signing-time attribute uses BinaryTime.  CMS and the signing-time
   attribute are defined in RFC 3852.

1.  Introduction

   This document specifies a new ASN.1 [ASN1] type for representing
   time:  BinaryTime.  This ASN.1 type can be used to represent date and
   time values.

   This document also specifies an alternative to the signing-time
   attribute used with the Cryptographic Message Syntax (CMS) [CMS]
   SignedData and AuthenticatedData content types, allowing the
   BinaryTime type to be used instead of the traditional UTCTime and
   GeneralizedTime types.

1.1.  BinaryTime

   Many operating systems represent date and time as an integer.  This
   document specifies an ASN.1 type for representing date and time in a
   manner that is also an integer.  Although some conversion may be
   necessary due to the selection of a different epoch or a different
   granularity, an integer representation has several advantages over
   the UTCTime and GeneralizedTime types.



Housley                       Experimental                   PAGE 1 top


RFC 4049 BinaryTime April 2005 First, a BinaryTime value is smaller than either a UTCTime or a GeneralizedTime value. Second, in some operating systems, the value can be used with little or no conversion. Conversion, when it is needed, requires only straightforward computation. If the endian ordering is different from the ASN.1 representation of an INTEGER, then straightforward manipulation is needed to obtain an equivalent integer value. If the epoch is different than the one chosen for BinaryTime, addition or subtraction is needed to compensate. If the granularity is something other than seconds, then multiplication or division is needed to compensate. Also, padding may be needed to convert the variable- length ASN.1 encoding of INTEGER to a fixed-length value used in the operating system. Third, date comparison is very easy with BinaryTime. Integer comparison is easy, even when multi-precision integers are involved. Date comparison with UTCTime or GeneralizedTime can be complex when the two values to be compared are provided in different time zones. This is a rare instance which both memory and processor cycles can be saved. 1.2. Binary Signing Time Attribute The signing-time attribute is defined in [CMS]. The alternative binary-signing-time attribute is defined in this document in order to obtain the benefits of the BinaryTime type. 1.3. Terminology In this document, the key words MUST, MUST NOT, REQUIRED, SHOULD, SHOULD NOT, RECOMMENDED, MAY, and OPTIONAL are to be interpreted as described in [STDWORDS]. 2. BinaryTime Definition The BinaryTime ASN.1 type is used to represent an absolute time and date. A positive integer value is used to represent time values based on coordinated universal time (UTC), which is also called Greenwich Mean Time (GMT) and ZULU clock time. The syntax for BinaryTime is: BinaryTime ::= INTEGER (0..MAX) Housley Experimental PAGE 2 top

RFC 4049 BinaryTime April 2005 The integer value is the number of seconds, excluding leap seconds, after midnight UTC, January 1, 1970. This time format cannot represent time values prior to January 1, 1970. The latest UTC time value that can be represented by a four-octet integer value is 03:14:07 on January 19, 2038, which is represented by the hexadecimal value 7FFFFFFF. Time values beyond 03:14:07 on January 19, 2038, are represented by integer values that are longer than four octets, and a five-octet integer value is sufficient to represent dates covering the next seventeen millennia. This specification uses a variable-length encoding of INTEGER. This permits any time value after midnight UTC, January 1, 1970, to be represented. When encoding an integer value that consists of more than one octet, which includes almost all the time values of interest, the bits of the first octet and bit 8 of the second octet MUST NOT all be ones or all zeros. This rule ensures that an integer value is always encoded in the smallest possible number of octets. However, it means that implementations cannot assume a fixed length for the integer value. 3. Binary Signing Time Attribute Definition The binary-signing-time attribute type specifies the time at which the signer (purportedly) performed the signing process. The binary- signing-time attribute type is intended for use in the CMS SignedData content type; however, the attribute can also be used with the AuthenticatedData content type. The binary-signing-time attribute MUST be a signed attribute or an authenticated attribute; it MUST NOT be an unsigned attribute, unauthenticated attribute, or unprotected attribute. The following object identifier identifies the binary-signing-time attribute: id-aa-binarySigningTime OBJECT IDENTIFIER ::= { iso(1) member-body(2) us(840) rsadsi(113549) pkcs(1) pkcs9(9) smime(16) aa(2) 46 } The binary-signing-time attribute values have ASN.1 type BinarySigningTime: BinarySigningTime ::= BinaryTime Housley Experimental PAGE 3 top

RFC 4049 BinaryTime April 2005 In [CMS], the SignedAttributes syntax and the AuthAttributes syntax are each defined as a SET OF Attributes. However, the binary- signing-time attribute MUST have a single attribute value, even though the syntax is defined as a SET OF AttributeValue. There MUST NOT be zero or multiple instances of AttributeValue present. The SignedAttributes contained in the signerInfo structure within SignedData MUST NOT include multiple instances of the binary- signing-time attribute. Similarly, the AuthAttributes in an AuthenticatedData MUST NOT include multiple instances of the binary- signing-time attribute. No requirement is imposed concerning the correctness of the signing time itself, and acceptance of a purported signing time is a matter of a recipient's discretion. It is expected, however, that some signers, such as time-stamp servers, will be trusted implicitly. 4. References This section provides normative and informative references. 4.1. Normative References [ASN1] CCITT. Recommendation X.208: Specification of Abstract Syntax Notation One (ASN.1). 1988. [CMS] Housley, R., "Cryptographic Message Syntax (CMS)", RFC 3852, July 2004. [STDWORDS] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, March 1997. 4.2. Informative References [TSP] Adams, C., Cain, P., Pinkas, D., and R. Zuccherato, "Internet X.509 Public Key Infrastructure Time-Stamp Protocol (TSP)", RFC 3161, August 2001. 5. Security Considerations Use of the binary-signing-time attribute does not necessarily provide confidence in the time when the signature value was produced. Therefore, acceptance of a purported signing time is a matter of a recipient's discretion. RFC 3161 [TSP] specifies a protocol for obtaining time stamps from a trusted entity. Housley Experimental PAGE 4 top

RFC 4049 BinaryTime April 2005 The original signing-time attribute defined in [CMS] has the same semantics as the binary-signing-time attribute specified in this document. Therefore, only one of these attributes SHOULD be present in the signedAttrs of a SignerInfo object or in the authAttrs of an AuthenticatedData object. However, if both of these attributes are present, they MUST provide the same date and time. Housley Experimental PAGE 5 top

RFC 4049 BinaryTime April 2005 Appendix A: ASN.1 Module The ASN.1 module contained in this appendix defines the structures that are needed to implement this specification. It is expected to be used in conjunction with the ASN.1 modules in [CMS]. BinarySigningTimeModule { iso(1) member-body(2) us(840) rsadsi(113549) pkcs(1) pkcs-9(9) smime(16) modules(0) 27 } DEFINITIONS IMPLICIT TAGS ::= BEGIN -- BinaryTime Definition BinaryTime ::= INTEGER (0..MAX) -- Signing Binary Time Attribute id-aa-binarySigningTime OBJECT IDENTIFIER ::= { iso(1) member-body(2) us(840) rsadsi(113549) pkcs(1) pkcs9(9) smime(16) aa(2) 46 } BinarySigningTime ::= BinaryTime END Author's Address Russell Housley Vigil Security, LLC 918 Spring Knoll Drive Herndon, VA 20170 USA EMail: housley@vigilsec.com Housley Experimental PAGE 6 top

RFC 4049 BinaryTime April 2005 Full Copyright Statement Copyright © The Internet Society (2005). This document is subject to the rights, licenses and restrictions contained in BCP 78, and except as set forth therein, the authors retain all their rights. This document and the information contained herein are provided on an "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Intellectual Property The IETF takes no position regarding the validity or scope of any Intellectual Property Rights or other rights that might be claimed to pertain to the implementation or use of the technology described in this document or the extent to which any license under such rights might or might not be available; nor does it represent that it has made any independent effort to identify any such rights. Information on the procedures with respect to rights in RFC documents can be found in BCP 78 and BCP 79. Copies of IPR disclosures made to the IETF Secretariat and any assurances of licenses to be made available, or the result of an attempt made to obtain a general license or permission for the use of such proprietary rights by implementers or users of this specification can be obtained from the IETF on-line IPR repository at http://www.ietf.org/ipr. The IETF invites any interested party to bring to its attention any copyrights, patents or patent applications, or other proprietary rights that may cover technology that may be required to implement this standard. Please address the information to the IETF at ietf- ipr@ietf.org. Acknowledgement Funding for the RFC Editor function is currently provided by the Internet Society. Housley Experimental PAGE 7 top

BinaryTime: An Alternate Format for Representing Date and Time in ASN.1 RFC TOTAL SIZE: 12302 bytes PUBLICATION DATE: Thursday, April 7th, 2005 LEGAL RIGHTS: The IETF Trust (see BCP 78)


RFC-ARCHIVE.ORG

© RFC 4049: The IETF Trust, Thursday, April 7th, 2005
© the RFC Archive, 2024, RFC-Archive.org
Maintainer: J. Tunnissen

Privacy Statement