The RFC Archive
 The RFC Archive   RFC 4558   « Jump to any RFC number directly 
 RFC Home
Full RFC Index
Recent RFCs
RFC Standards
Best Current Practice
RFC Errata
1 April RFC



IETF RFC 4558

Node-ID Based Resource Reservation Protocol (RSVP) Hello: A Clarification Statement

Last modified on Saturday, June 10th, 2006

Permanent link to RFC 4558
Search GitHub Wiki for RFC 4558
Show other RFCs mentioning RFC 4558







Network Working Group                                             Z. Ali
Request for Comments: 4558                                     R. Rahman
Category: Standards Track                                   D. Prairie
                                                           Cisco Systems
                                                        D. Papadimitriou
                                                                 Alcatel
                                                               June 2006


       Node-ID Based Resource Reservation Protocol (RSVP) Hello:
                       A Clarification Statement

 Status of This Memo

   This document specifies an Internet standards track protocol for the
   Internet community, and requests discussion and suggestions for
   improvements.  Please refer to the current edition of the "Internet
   Official Protocol Standards" (STD 1) for the standardization state
   and status of this protocol.  Distribution of this memo is unlimited.

 Copyright Notice

   Copyright © The Internet Society (2006).

 Abstract

   Use of Node-ID based Resource Reservation Protocol (RSVP) Hello
   messages is implied in a number of cases, e.g., when data and control
   planes are separated, when TE links are unnumbered.  Furthermore,
   when link level failure detection is performed by some means other
   than exchanging RSVP Hello messages, use of a Node-ID based Hello
   session is optimal for detecting signaling adjacency failure for
   Resource reSerVation Protocol-Traffic Engineering (RSVP-TE).
   Nonetheless, this implied behavior is unclear, and this document
   formalizes use of the Node-ID based RSVP Hello session in some
   scenarios.  The procedure described in this document applies to both
   Multi-Protocol Label Switching (MPLS) and Generalized MPLS (GMPLS)
   capable nodes.













Ali, et al.                 Standards Track                  PAGE 1 top


RFC 4558 Node-ID Based RSVP Hello June 2006 1. Introduction The RSVP Hello message exchange was introduced in [RFC 3209]. The usage of RSVP Hello has been extended in [RFC 3473] to support RSVP Graceful Restart (GR) procedures. More specifically, [RFC 3473] specifies the use of the RSVP Hello messages for GR procedures for Generalized MPLS (GMPLS). GMPLS introduces the notion of control plane and data plane separation. In other words, in GMPLS networks, the control plane information is carried over a control network whose end-points are IP capable and that may be physically or logically disjoint from the data bearer links it controls. One of the consequences of separation of data bearer links from control channels is that RSVP Hello messages are not terminated on data bearer links' interfaces even if (some of) those are numbered. Instead, RSVP Hello messages are terminated at the control channel (IP-capable) end-points. The latter MAY be identified by the value assigned to the node hosting these control channels, i.e., Node-ID. Consequently, the use of RSVP Hello messages for GR applications introduces a need for clarifying the behavior and usage of Node-ID based Hello sessions. Even in the case of packet switching capable interfaces, when link failure detection is performed by some means other than RSVP Hello messages (e.g., [BFD]), the use of Node-ID based Hello sessions is also optimal for detection of signaling adjacency failures for GMPLS-RSVP-TE and RSVP-TE when there is more than one link between a pair of nodes. Similarly, when all TE links between neighbor nodes are unnumbered, it is implied that the nodes will exchange Node-ID based Hello messages for detection of signaling adjacency failures. This document also clarifies the use of Node-ID based Hello message exchanges when all or a sub-set of TE links are unnumbered. 2. Terminology Node-ID: TE Router ID as advertised in the Router Address TLV for OSPF [OSPF-TE] and Traffic Engineering Router ID TLV for ISIS [ISIS-TE]. For IPv6, the Node-ID refers to the Router_IPv6_Address for OSPFv3 [OSPFv3-TE] and the IPv6 TE Router_ID for IS-IS [IS-ISv6-TE]. Node-ID based Hello Session: A Hello session in which local and remote Node-IDs are used in the source and destination fields of the Hello packet, respectively. Interface bounded Hello Session: A Hello session in which local and remote addresses of the interface in question are used in the source and destination fields of the Hello packet, respectively. Ali, et al. Standards Track PAGE 2 top

RFC 4558 Node-ID Based RSVP Hello June 2006 2.1. Conventions Used in This Document The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC 2119 [RFC 2119]. 3. Node-ID Based RSVP Hello Messages A Node-ID based Hello session is established through the exchange of RSVP Hello messages such that local and remote Node-IDs are respectively used in the source and destination fields of Hello packets. Here, for IPv4, Node-ID refers to the TE router-id as defined in the Router Address TLV for OSPF [OSPF-TE] and the Traffic Engineering router ID TLV for ISIS [ISIS-TE]. For IPv6, the Node-ID refers to the Router_IPv6_Address for OSPFv3 [OSPFv3-TE] and the IPv6 TE Router_ID for IS-IS [IS-ISv6-TE]. This section formalizes a procedure for establishing Node-ID based Hello sessions. If a node wishes to establish a Node-ID based RSVP Hello session with its neighbor, it sends a Hello message with its Node-ID in the source IP address field of the Hello packet. Furthermore, the node also puts the neighbor's Node-ID in the destination address field of the IP packet. When a node receives a Hello packet where the destination IP address is its local Node-ID as advertised in the IGP-TE topology, the node MUST use its Node-ID in replying to the Hello message. In other words, nodes MUST ensure that the Node-IDs used in RSVP Hello messages are those derived/contained in the IGP-TE topology. Furthermore, a node can only run one Node-ID based RSVP Hello session per IGP instance (i.e., per Node-ID pair) with its neighbor. Even in the case of packet switching capable interfaces, when link failure detection is performed by some means other than exchanging RSVP Hello messages, use of Node-ID based Hello sessions is also optimal in detecting signaling adjacency failures for GMPLS-RSVP-TE and RSVP-TE when there is more than one link between a pair of nodes. Similarly, if all interfaces between a pair of nodes are unnumbered, the optimal way to use RSVP to detect signaling adjacency failure is to run Node-ID based Hello sessions. Furthermore, in the case of an optical network with single or multiple numbered or unnumbered control channels, use of Node-ID based Hello messages for detecting signaling adjacency failure is also optimal. Therefore, when link failure detection is performed by some means other than exchanging RSVP Hello messages, or if all interfaces between a pair of nodes are unnumbered, or in a GMPLS network with data and control plane separation, a node MUST run Node-ID based Hello sessions for detection of signaling adjacency failure for RSVP-TE. Nonetheless, Ali, et al. Standards Track PAGE 3 top

RFC 4558 Node-ID Based RSVP Hello June 2006 if it is desirable to distinguish between signaling adjacency and link failures, Node-ID based Hello sessions can co-exist with the exchange of interface bound Hellos messages. Similarly, if a pair of nodes share numbered and unnumbered TE links, Node-ID and interface based Hello sessions can co-exist. 4. Backward Compatibility Note The procedure presented in this document is backward compatible with both [RFC 3209] and [RFC 3473]. Per [RFC 3209], the Hello mechanism is intended for use between immediate neighbors, and Hello messages are by default sent between direct RSVP neighbors. This document does not modify this behavior, as it uses as "local node_id" the IPv4/IPv6 source address of the sending node and as "remote node_id" the IPv4/IPv6 destination address of the neighbor node. TTL/Hop Limit setting and processing are also left unchanged. Moreover, this document does not modify the use of Hello Processing for State Recovery as defined in Section 9.3 of [RFC 3473] (including definition and processing of the RESTART_CAP object). 5. Security Considerations As this document does not modify or extend the RSVP Hello messages exchange between immediate RSVP neighbors, it does not introduce new security considerations. The security considerations pertaining to the original [RFC 3209] remain relevant. RSVP message security is described in [RFC 2747] and provides Hello message integrity and authentication of the Node-ID ownership. 6. Acknowledgements We would like to thank Anca Zamfir, Jean-Louis Le Roux, Arthi Ayyangar, and Carol Iturralde for their useful comments and suggestions. Ali, et al. Standards Track PAGE 4 top

RFC 4558 Node-ID Based RSVP Hello June 2006 7. Reference 7.1. Normative References [RFC 2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, March 1997. [RFC 2747] Baker, F., Lindell, B., and M. Talwar, "RSVP Cryptographic Authentication", RFC 2747, January 2000. [RFC 3209] Awduche, D., Berger, L., Gan, D., Li, T., Srinivasan, V., and G. Swallow, "RSVP-TE: Extensions to RSVP for LSP Tunnels", RFC 3209, December 2001. [RFC 3473] Berger, L., "Generalized Multi-Protocol Label Switching (GMPLS) Signaling Resource ReserVation Protocol-Traffic Engineering (RSVP-TE) Extensions", RFC 3473, January 2003. 7.2. Informative References [OSPF-TE] Katz, D., Kompella, K., and D. Yeung, "Traffic Engineering (TE) Extensions to OSPF Version 2", RFC 3630, September 2003. [ISIS-TE] Smit, H. and T. Li, "Intermediate System to Intermediate System (IS-IS) Extensions for Traffic Engineering (TE)", RFC 3784, June 2004. [BFD] Katz, D. and D. Ward, "Bidirectional Forwarding Detection", Work in Progress. [IS-ISv6-TE] Harrison, J., et al. "IPv6 Traffic Engineering in IS- IS", Work in Progress, November 2005. [OSPFv3-TE] Ishiguro, K., et al. "Traffic Engineering Extensions to OSPF version 3", Work in Progress, April 2006. Ali, et al. Standards Track PAGE 5 top

RFC 4558 Node-ID Based RSVP Hello June 2006 Authors' Addresses Zafar Ali Cisco Systems Inc. 100 South Main St. #200 Ann Arbor, MI 48104, USA Phone: (734) 276-2459 EMail: zali@cisco.com Reshad Rahman Cisco Systems Inc. 2000 Innovation Dr., Kanata, Ontario, K2K 3E8, Canada Phone: (613) 254-3519 EMail: rrahman@cisco.com Danny Prairie Cisco Systems Inc. 2000 Innovation Dr., Kanata, Ontario, K2K 3E8, Canada Phone: (613) 254-3544 EMail: dprairie@cisco.com Dimitri Papadimitriou Alcatel Fr. Wellesplein 1, B-2018 Antwerpen, Belgium Phone: +32 3 240-8491 EMail: dimitri.papadimitriou@alcatel.be Ali, et al. Standards Track PAGE 6 top

RFC 4558 Node-ID Based RSVP Hello June 2006 Full Copyright Statement Copyright © The Internet Society (2006). This document is subject to the rights, licenses and restrictions contained in BCP 78, and except as set forth therein, the authors retain all their rights. This document and the information contained herein are provided on an "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Intellectual Property The IETF takes no position regarding the validity or scope of any Intellectual Property Rights or other rights that might be claimed to pertain to the implementation or use of the technology described in this document or the extent to which any license under such rights might or might not be available; nor does it represent that it has made any independent effort to identify any such rights. Information on the procedures with respect to rights in RFC documents can be found in BCP 78 and BCP 79. Copies of IPR disclosures made to the IETF Secretariat and any assurances of licenses to be made available, or the result of an attempt made to obtain a general license or permission for the use of such proprietary rights by implementers or users of this specification can be obtained from the IETF on-line IPR repository at http://www.ietf.org/ipr. The IETF invites any interested party to bring to its attention any copyrights, patents or patent applications, or other proprietary rights that may cover technology that may be required to implement this standard. Please address the information to the IETF at ietf-ipr@ietf.org. Acknowledgement Funding for the RFC Editor function is provided by the IETF Administrative Support Activity (IASA). Ali, et al. Standards Track PAGE 7 top

Node-ID Based Resource Reservation Protocol (RSVP) Hello: A Clarification Statement RFC TOTAL SIZE: 14185 bytes PUBLICATION DATE: Saturday, June 10th, 2006 LEGAL RIGHTS: The IETF Trust (see BCP 78)


RFC-ARCHIVE.ORG

© RFC 4558: The IETF Trust, Saturday, June 10th, 2006
© the RFC Archive, 2024, RFC-Archive.org
Maintainer: J. Tunnissen

Privacy Statement